20
MULTIPLE UNIT SET UP/SET UNIT ID NUMBERS
Up to seven (7) units can be installed on a signal telephone line. Each unit must have a unique number. from 1 to 7.
If you have Call Waiting, you may receive up to two (2) calls from more than one source. For example, if a visitor calls
you from the main gate (unit 1), and another visitor tries to call from the rear gate (unit 2), you will be notified by the call
waiting beep(s).
The unit connected to the phone line closest to the residence should be configured as unit number 1, and the unit
connected to the phone line farthest from the residence and closed to the telephone company should be configured as
the highest unit number.
1. Press
4. Press
2. Enter Unit ID Code [Unit Number] (1-7)
3. Enter total number of units in chain (2-7)
Sets the Unit ID Code as "#5" in a chain of "7" units.
EXAMPLE:
1
2
3
4
To Set the Unit ID Number
1. Press
2. Press
Verify the Unit Number
Adding or removing units will require the Unit IDs to be re-entered. The Unit ID can ONLY be programmed using the
unit’s keypad.
Unit ID Se
qu
encial Order
Nu
m
b
er of Units in Chain “7”
Unit ID “1”
Residence
Unit ID “2”
Unit ID “3”
Unit ID “7”
Telco Entrance Box
Demarcation Point
1
2
3
4
5
6
7
8
9
0
#
HANG UP
CALL
1
2
3
4
5
6
7
8
9
0
#
HANG UP
CALL
1
2
3
4
5
6
7
8
9
0
#
HANG UP
CALL
1
2
3
4
5
6
7
8
9
0
#
HANG UP
CALL
COMPLETE THE INSTALLATION
Once you have finished testing and adjusting the unit, the next step is to program the unit for the customer’s specific
requirements. Refer to the programming manual for information.
Summary of Contents for Crown Jewel
Page 21: ...21 NOTES ...
Page 22: ...22 NOTES ...