Sentex Crown Jewel, Installation Manual, Page: 17 / 24

EXIT EXIT A
UT
OCALL
TB3 PHONE LINE
TB5 TB4 COM
PM1 PM2
HOUSE TELCO
DS1
DS4
"SLIC"
DS3
EARTH GND
EXT
8
Jumper
Wire
EXIT
1
COM
EXIT EXIT A
UT
OCALL
TB3 PHONE LINE
TB5 TB4 COM
PWR IN
RELA
Y 2
RELA
Y 1
PM1 PM2 PM3 PM4 PM5 PM6 PM7
HOUSE TELCO
KEYPAD
VR1
"SPEAKER LEVEL"
DS1
DS55
DS8
DS9
DS4
MIC
DS6
DS7
"HOLD"
"SLIC"
"RING"
DS2
"TELCO"
DS3
"HOME"
VR2
"FEEDBACK"
EARTH GND
EXTENRAL KEYPAD
1
17
POWERING UP AND TESTING THE UNIT
Plug the transformer into the
110 Vac outlet. Check the “DS8”
Power LED is illuminated.
PLUG TRANSFORMER INTO OUTLET
RELAY #1 Insert a jumper wire as shown. Verify
that Relay #1 activates for the default
10 seconds and that the gate/door
opens properly. It the relay does not
activate properly, check wiring and
retest.
TEST GATE/DOOR RELAYS
EXIT EXIT A
UT
OCALL
TB3 PHONE LINE
TB5 TB4 COM
PM1 PM2
HOUSE TELCO
DS1
DS4
"SLIC"
DS3
EARTH GND
EXT
8
Jumper
Wire
EXIT
2
COM
RELAY #2 Insert a jumper wire as shown.
•
If installed for Control: Verify that
Relay #2 activates for the default
10 seconds and that the gate/door
opens properly.
• If installed for Shunt, Alarm, or
CCTV:
Program the Auxiliary Relay
Configuration (Programming Step
#26, see the Programming Manual
for information). Verify that Relay
#2 activates and that the
connected device performs as
expected.
If relay does not activate properly,
check wiring and retest.