Sentex Crown Jewel, Installation Manual, Page: 19 / 24

19
VERIFY THE TELEPHONE CONNECTIONS
If you have a telephone test set (buttset) with a monitor mode, you can test the connection to the resident's
telephone using the following procedure.
1. Place test set in monitoring mode.
2. Connect the test set clips to the pins marked
“TELCO” (1) on the bypass board and make sure
a dial tone is emitted from the test set.
3. Connect the test set clips to the pins marked
“HOME” (2) on the bypass board and make sure a
dial tone is emitted from the test set.
If you do not have access to a telephone test set, test the connection using the following procedure.
1. Place a telephone call from the resident’s
telephone to verify it is operating properly, then
hang up the phone.
2. Press the “#” key on the unit’s keypad. The
telephone in the residence should ring.
3. Have someone answer the phone and press “9”
(1) to activate Relay #1, the relay should activate.
Then have them press “5” (2) to activate relay #2,
the relay should activate.
OPERATE BYPASS
Ring
HOME
Tip 1 2 3 4 Ring
TELCO
Tip
SYSTEM
Bypass Board
Telephone Test Set
1 2
Cro w n Je w el Keypad
1 2