www.sentera.eu
MIW-MTP-G010-AT-EN-000 - 29 / 08 / 2018
6 - 7
back to the table of contents
4.
Mount the internal enclosure into the wall according to the mounting dimensions
shown in
Fig. 2
Mounting dimensions - inset mounting.
Fig. 2 Mounting dimensions - inset mounting
26
33
50x50
82
89
62
50
62
60
In case 24 VAC supply voltage is used, do not connect the input GND terminal
with the output GND terminal.
ATTENTION
NOTE
Mount the unit so that the terminal block and connections are at the lower side.
5.
Adjust the Vmin and Vmax trimmers.
6.
Mount back the cover and secure it with the nut.
7.
Put back the knob and turn it to off position.
8.
Turn on the power supply.
For surface mounting
1.
Remove the knob by turning it to the right until it pops out.
2.
Unscrew the nut to remove the cover of the external enclosure.
3.
Mount the external enclosure onto the surface by means of screws and dowels
(not included) adhering to the mounting dimensions shown in
Fig. 3
Mounting
dimensions - surface mounting.
Fig. 3 Mounting dimensions - surface mounting
82
89
69
82
62
62
4.
Insert the cables through the grommets.
5.
Do the wiring according to the wiring diagram (see
Fig. 1
Wiring and connections
).
6.
Insert the internal enclosure into the external one and fix it using the screws and
washers included in the set.
NOTE
Mount the unit so that the terminal block and connections are at the lower side.
7.
Mount back the cover and secure it with the nut.
8.
Put back the knob and turn it to off position.
9.
Turn on the power supply.
MTP-G010-AT
ACTIVE
POTENTIOMETER
