Sentec SDM, Service Manual

Page: 14 / 93

1 Introduction
HB-005615-j 8
additional safety measures may be required to be compliant with
the requirements of IEC 60601-1. In case of doubt consult
qualified technicians.
WARNING: The Roll Stand, model RS_SDM, is intended for use
with the SDM only or in combination with the Cable Cleat, model
CC_SDM, and the SDM. The mounting plates are intended for
use with the SenTec Digital Monitor (SDM) only. Do not use the
accessories for devices from other manufacturers than SenTec
together with SenTec Digital Monitoring System (SDMS).
WARNING: Do not attach the basket of the Roll Stand, model
RS_SDM, in any position that might cause it to tip over and
possibly fall on the patient. Ensure that the Roll Stand does not
tip over with and without the SDM being mounted to it.
WARNING: This warning applies to all SDMs with serial
numbers less than or equal to 302968 provided that the open
thread has not been replaced by a blind thread already or is not
sealed with slotted setscrew and thread locking adhesive. A
screw entering 17 mm (0.67 inches) into one of the SDM’s screw
holes may touch the primary part of the SDM’s power supply. If
this screw is electrically conducting the resulting short circuit
may cause an electrical isolation failure and, consequently, if the
SDM is connected to AC power an electrical shock may occur to
a person touching this screw or any other electrically conducting
material being in contact with this screw.
CAUTION: To maintain monitor readiness in-between
monitoring if using a SenTec TC Sensor:
1.
ALWAYS clean the sensor before putting it into the
Docking Station!
2. ALWAYS store the clean sensor in the Docking Station!
3. ALWAYS keep the monitor switched on!
CAUTION: Do not immerse the SDM nor the connectors of any
connecting cables in liquid solution. Plugs and connectors
meticulously have to be kept clean and dry at all times.