EN-8
EN
Coffeemaker
SCE 3050SS / SCE 3051RD
Revision
05/2016
Copyright © 2016, Fast ČR, a.s.
oPeRaTInG THe CoffeeMaKeR
1 . Open the lid A
1
and fill the water tank A
3
with the required amount of water . The water level
must at least cover the mark showing two water cups and must not go over the maximum mark
showing 10 water cups (i .e . 1 .25 l) .
attention:
Only fill the water tank with cold drinking water . Do not use hot water .
The water tank has a maximum capacity of 1 .25 litres of water .
The amount of brewed coffee will always be less than the amount of water you poured into
the water tank A
3
. During the coffee brewing process, approximately 10 % of the water is
absorbed by the ground coffee .
2 . Place the permanent filter A
7
or a disposable paper filter size no . 4 into the filter holder A
8
.
3 . Pour ground coffee into the filter . Recommended dosage: 7 g of ground coffee per cup . Set the hot
water arm A
2
so that it points above the filter .
note:
If you wish to brew tea, pour the required amount of tea into the filter .
4 . Shut the lid A
1
and make sure that it is properly closed .
5 . Place the glass kettle with the lid A
qs
on to the hotplate A
qd
and start the coffeemaker by setting
switch A
qf
to position I (On) . The red indicator light will be lit .
6 . Once the entire batch of coffee has finished brewing, wait approximately 1 minute for the drip
process to complete fully . Now the coffee can be served .
7 . If you wish to serve the coffee later, leave the kettle A
qs
on the hotplate A
qd
. The hotplate A
qd
will
keep the coffee at an optimal serving temperature . The coffeemaker will automatically turn itself
off after 40 minutes of operation .
8 . Once you empty the kettle, return it back on to the hotplate A
qd
and turn off the coffeemaker by
setting switch A
qf
to position 0 (Off) . The red indicator light will turn off .
9 . Allow the coffeemaker to cool down for at least 10 minutes before using it again .
Warning:
If you do not allow the coffeemaker to cool down, the water could overheat and result in
subsequent scalding by the escaping steam .
10 . Before using the coffeemaker again, remove the coffee grounds and wash the permanent filter
A
7
or remove the paper filter together with the coffee grounds and dispose of it together with
normal household waste . Rinse the filter holder A
8
and the kettle A
qs
with clean water . Dry it and
put it back in its place .
11 . When not using the coffeemaker, turn it off and disconnect it from the power socket .
DRIP-sToP fUnCTIon
•
The Drip-Stop function will allow you to serve coffee before the end of the drip process .
1 . Once at least half the amount of coffee is brewed, you may remove the kettle A
qs
from the
coffeemaker . The Drip-Stop shut-off valve will be activated and coffee will stop dripping .
2 . Serve the required amount of coffee and place the kettle A
qs
back on the hotplate A
qd
within
approximately 1 minute of taking it off to avoid the filter from overfilling with hot water .
3 . When the kettle A
qd
is placed back under the brew chamber A
9
, the drip process will resume
automatically .
