Sensor Technology RWT420, User Manual

Page: 69 / 69

Revision 7 Jan 17  Sensor Technology 2012
Page 12
TSE3168V
Transducer Status Lights - Interpretation and actions:
Mode Warnings Errors
Peak mode
One of the peak options has
been selected in either the
transducer control software or
by using the analog lead
contact closure on pin 8.
Analog Scaling
The full scale of the analog out
has been changed to a user-
selected scale in the
transducer control program.
Limits
Limits output has been
triggered
Analog Fault CH0
In voltage output mode the
analog output pin is short circuit,
in current output mode the
analog output pin is open circuit.
Check the analog connector
wiring on Channel 0.
Analog Fault CH1
In voltage output mode the
analog output pin is short circuit,
in current output mode the
analog output pin is open circuit.
Check the analog connector
wiring on Channel 1.
Zero Offset High
There may be an offset applied
to the current torque applied
value because the ‘Zero Peaks’
has been pressed while torque,
greater than 10% of the fsd, has
been applied.
Exceeded temp
Shaft temperature has exceeded
normal operating conditions.
Temperature compensation may
no longer effective or calibration
valid.
Overscale
Torque has been applied greater
than the specified FSD.
Critical overscale
Torque has been applied greater
than 120% of the FSD.
Contact factory if warning
continues.
Head Disconnect
Lead has been disconnected
from the transducer.
Capture Board
The DSP has failed to
initialise. Power cycle the
transducer.
Contact factory if error
continues.
SAWS
A SAW device has failed.
Contact factory if error
continues.
Failed Temp sensor
The infrared temperature
sensor has failed.
Temperature compensation is
ineffective.
Contact factory if error
continues.
Irregular Voltage
One or more of the internal
voltages is not within
specification.
Check the input power supply
is within specification of the
data sheet.
Contact factory if error
continues.
Additional Information
There is no requirement to install LabVIEW because TorqView is a self-running executable
file.
However, if LabVIEW is installed and there is a requirement to make unique programs or
allow TorqView to communicate with other LabVIEW programmes, VI’s are available from
Sensor Technology on the website www.sensors.co.uk at:
http://sensors.co.uk/products/pages/labvi.html