Sensor Technology 2016
Page 15
RWT3745V (Rev 2)
Digital Command
There are multiple digital commands to select the different zero modes, refer to the
transducer communication protocol manual.
Our Torqview and Transducer Control software programs implement these commands
providing a simple way of zeroing the transducer.
Resetting transducer to factory default
To reset the transducer to the factory default settings (i.e. the functions set by the factory on
purchase) follow the steps below:
1. Turn off transducer.
2. While holding in the zero button, power the transducer. The LED will stay solid green
until the zero button is released.
3. Allow the transducer to carry out its BIT procedure.
4. When the LED is solid green all user-adjusted parameters will have been reset to the
factory defaults.
Summary of Contents for RWT420
Page 23: ......
Page 31: ...Transducer Control 5 User Manual Revision 5 December 2016...
