SensoData 5500
3
– Operator’s Manual
Besides the basic version are also specialized versions with built-in transducers, which are the stand-alone integrated
devices such as: anemometer or thermometer.
The following versions of the device are accessible:
SensoData 5500
basic version enabling attaching external transducers or modules,
SensoData 5500 Bee
basic version with the built-in wire-less receiver,
SensoData 5500 Anemo
version with built-in anemometer transducer and with the socket for connecting the
measuring probe,
SensoData 5500 Anemo B
version with built-in anemometer transducer and with the sensor of barometric
pressure,
SensoData 5500 Thermo
version with built-in temperature transducer enabling connecting two temperature
probes,
SensoData 5500 Thermo HB
version with built-in temperature and humidity transducer and barometric pressure
sensor, enabling connecting two probes of temperature or one temperature probe
and one humidity probe,
SensoData 5500
version with built-in temperature transducer enabling connecting four temperature
probes.
All specialized versions are equipped with the additional
RJ45 socket enabling to attach external transducers or
modules. In the photo is presented general view with sockets
and indicators:
A – USB socket to connect to a computer
B – socket (depending on the version) to connect the
probes or modules
C – RJ45 socket to connect additional transducers or
module (only for version Anemo and Thermo).
D – diode
of
the
activity
of
the
wire-less
communication
*)
E – external power connector
Technical Data:
- averaging time: 10s…100min
- logging interval: 10s…100min
- logging time: 1min…100h
- sampling rate: 8 Hz
- display: LCD graphic 128x64
- interface: RS485, USB
- baud rate: 11500 bps
- wire-less protocol: Zig-Bee
1
)
- range of wire-less comm. : 60m
1
)
- operation temperature: -20…50
O
C
1)
Only for version SensoData 5500 Bee
2)
It is not recommended to place the dataloggert below -5
O
C due to reduction of dynamic range and contrast of the LCD and
battery performance. In this case is recommended removal of the datalogger outside the measuring environment and the
connection of the measuring module long cable.
Power supply depending on the option:
- 4 rechargeable batteries Ni-Mh type AA
(with low self-discharge, ready to use) or
- 4 alkaline batteries type AA 1.5V or
- external 6V DC/1A adapter
Note !
Battery charging should be in a separate charger
delivered together with the device. To do this, remove the
batteries from a container on the back of the device.
