Sensopart FT 80 RLA 500-L8, Mounting And Operating Instructions, Page: 41 / 65

FT 80 RLA Distance sensor - 068-13715 - 04.05.2009-03
Mounting and
operating instructions
41
Bus commands
Command
(ASCII)
3
rd byte
Hex
Description
of command
Master parameters
(4th byte and following) hex
1 31 Signal output Q
1
1 High byte switching point 1 see 1) page 42
2 Low byte switching point 1 see 1) page 42
3
Configuration:
D0: 1 = N.O., 0 = N.C
D1: 1= pulse stretching
0 = off, see 2) page 42
4 High byte switching point 2 see 1) page 42
5
Low byte switching point 2
is sent for high and low byte 00, if there is no
second switching point, see 1) page 42
2 32 Signal output Q
2
1 High byte switching point 1 see 1) page 42
2 Low byte switching point 1 see 1) page 42
3 Configuration:
D0: 1 = N.O., 0 = N.C
D1: 1= pulse stretching
0 = off, see 2) page 42
4 High byte switching point 2 see 1) page 42
5 Low byte switching point 2
is sent for high and low byte 00, if there is no
second switching point, see 1) page 42
G 47 Good Target
T 54 Q
1
is trigger input
E 45 Q
1
is enable input
B 42 Averaging
D0 = 1 = 0.4 ms (averaging off)
D1 = 1 = 4 ms (10 measured values)
D2 = 1 = 40 ms (100 measured values)
N 4E Characteristic curve 0% point See 1) page 42
H 48 Characteristic curve 100% point See 1) page 42
Z 5A Q
1
is automatic zero
C 43 Q
1
is automatic centre
X 58 Maximum search
M 4D Minimum search
D 44 Difference search
W 57 Factory setting
V 56 Key lock
Settings see 2) page 42
D0 = 0 not active
D0 = 1 active
S 53 Store EEPROM
Q 51
Q
1
input software confirmation
explanation
Settings see 2) page 42
D0 = 0 Q
1
= off
D0 = 1 Q
2
= on
A 41 Distance measuring values See 3) page 42
I 49 Operating measuring values See 3) page 42
F 46 Fast measured value output See 4) page 42
L 4G Change slave address See 2) page 42
? 3F Read sensor setting See 5) page 42