Sensata Dimensions 141537, Owner'S Manual

Page: 7 / 26

Page 7
Operation
LCD Remote Manual
Inverter Power Mode (Using the LCD Remote)
Turning the Inverter “On” or “Off” (no AC applied)
1. Select the “On/Off ” button to turn on the inverter.
2. Select the “On/Off ” button again to turn the inverter off.
This example message shows that the inverter is on, the load is consuming 550 watts of power and that the battery
voltage is measured at 12.6 volts.
Standby Mode
The inverter standby feature allows the inverter to automatically turn on anytime that it senses a loss of shore
power. It returns to standby when shore power is restored. The inverter/charger will qualify the AC power 30
seconds after the AC power has been applied to the AC input.
This message is stating that the inverter is in standby and the charger is running. If AC power is removed, the
inverter will automatically turn on. This message will show for 15 seconds before reverting to the charger status.
This message is stating that inverter mode will not be enabled if AC power is removed. To change this, select the
“On/Off ” button.
Other Inverter Messages
Low battery condition due to start surge or undersized battery cable gauge. If this condition remains for ≥ 5
seconds, the inverter will shut down.
Overload condition due to excessive loads or short circuit. If this condition remains for ≥ 5 seconds, the inverter
will shut down.
INVERT 1 550 WATT
BATT 12.6 VOLTS
INVERT - STANDBY
OVERRIDE BY CHGR
INVERT LOW BATT
BATT 9.8 VOLTS
INV ERT OVERLOAD
BATT 11.8 VOLTS
INVERTER - OFF
PUSH FOR ON