Sennheiser EM 100 G3, Manual

Page: 22 / 30

Adjustment tips
20
왘
Select a channel on your receiver (“ Current List ”, see page 17).
The receiving frequency of the channel must be approved and legal in your country
(see above).
왘
Synchronize a transmitter with the receiver via the infra-red interface (see page 13).
This establishes a transmission link between the transmitter and the receiver.
Alternatively, you can set the channel on the transmitter manually:
왘
Make sure that you set the transmitter to the same frequency bank and the same chan-
nel as the receiver.
For information on the setting options of the transmitter, refer to the instruction manual
of the transmitter.
Synchronizing transmitters with receivers – multi-channel operation
왘
Switch off all transmitters of your system that are to be automatically configured.
Channels used by switched-on transmitters are displayed as “used”.
왘
With one of the receivers, perform a frequency preset scan to scan the frequency banks
for unused channels (“
Scan New List ”, see page 17).
왘
Select a channel on this receiver (“ Current List ”, see page 17).
The receiving frequency of the channel must be approved and legal in your country
(see above).
왘
Synchronize a transmitter with the receiver via the infra-red interface (see page 13).
This establishes a transmission link between the transmitter and the receiver.
왘
Repeat for the remaining transmitter and receiver pairs as described above.
Your multi-channel system is now set up.
Alternatively, you can set the channel on the transmitter manually:
왘
Make sure that you set the transmitter to the same frequency bank and the same chan-
nel as the receiver.
For information on the setting options of the transmitter, refer to the instruction manual
of the transmitter.
You can also freely select the receiving frequencies and store these frequencies in the
frequency bank “
U ”.
If you want to use the frequency bank “ U ”:
왘
Make sure to use receivers of the same frequency range (see page 4 and the type plate
of the receiver).
왘
Only use frequencies that are approved and legal in your country (see page 19).
왘
Set each receiver to the same frequency bank.
왘
On one of the receivers, select a channel within this frequency bank (see page 18).
If you are using the frequency bank “ U ”, it might be that the receiving frequencies
are not intermodulation-free:
왘
For possible frequency combinations, please refer to the frequency information
sheet or calculate the frequencies (see below).
To ensure that the desired frequencies are intermodulation-free, proceed as follows:
왘
Calculate intermodulation-free frequencies using the “ Sennheiser Intermodula-
tion and Frequency Management (SIFM) ” software (see www.sennheiser.com).