If the connector optical properties are insufficient to use, you can modify the connector
properties by re-inserting the fiber and adjust the splice statement.
2 - Push the inserted fiber and create the bend again
DO NOT PULL FIBER OUT FROM THE CONNECTOR
EPS-1108-001-04
1 – Remove the
boot and attach
the wedge on a
connector again
(make sure there
is no space
between the
wedge and the
connector)
Grip the tube 80+/-10 mm
position from the end of the
connector
Push the arm to
remove the wedge
3 - Remove
the Wedge
Attention
!
4 – Re-install the boot
