★
Wear safety glasses
before handling optical fiber
to protect the eyes. Small pieces of glass fiber are
very sharp and might get into the eyes or under
the skin and cause injury.
★
Never look into
the end of a connector or an optical
fiber which may have a laser coupled to it. Laser
light may damage your eyes. Please note that
laser light is not visible.
★
If working in high places, please be careful not to
drop any tools.
(Please use a
wrist strap etc.
)
Connector (with wedge): 10pcs
Boot: 10pcs
Fiber holder for 900 µm fiber: 1pc
Assembling Jig:1pc
Composition
For your safety operation
This product has been designed and
manufactured to assure personal safety. Improper
operation can result in bodily injury and serious
damage to this product. Please read and observe all
warnings instructions given in this operation manual.
1. Improper assembly will result in a loss of performance.
Please read instructions
given in this operation manual.
2. The product is sensitive to dirt or dust. Do not take
connector out of the package
until it is to be used
.
3. The performance will be influenced by the cleaved fiber
surface condition. Please use a cleaver that has a good
blade.
4. Please
insert the fiber into the connector slowly
. If the fiber
is roughly inserted, it might be damaged or broken,
leading to product failure . Broken fiber could be scattered
in all directions.
5. Do not remove the dust cap
until the connector has been
completely assembled
.
6.
A proper amount of index matching gel is applied in the
connector. Do not
insert fiber more than once.
7.
Product properties are referenced to specification No.
EPS-0109-002-xx
Precautions
Following tools shall be required for assembling the
above parts,
1. Fiber Cleaver
2. Jacket Remover
1 Fiber cleaver FC-7
!
Assembling Jig
Fiber Holder for
900µm fiber
Assembly tools example
Boot
2 Jacket remover JR-25
LC for
900µm fiber
2 Jacket remover JR-M03
0.9 to 0.25mm
0.25 to 0.125mm
XP Fit Plus LC 900 µm
Field Installable Connector
Instruction Manual
(ETP-1108-001-01)
