ENGLISH 7/8
MI004301-E
SW2: SCALE AND MODE OUTPUT
POSITION
OUTPUT
POSITION
OUTPUT
7 8
RANGE
7 8
MODE
X
0..20mA / 0..10V
X
NORMAL
X
4..20mA / 2..10V
X
REVERSE
SW3: OUTPUT TYPE
POSITION
OUTPUT POSITION
OUTPUT
1 2
TYPE
1 2
TYPE
VOLTAGE
CURRENT
LEGEND
ON
OFF
6.4
CONFIGURATION THROUGH A PC
By using a PC and EASY SETUP software, it is possible to set: input type, input start and end of scale,
measurement type, rejection filter, resolution, output type, output start and end of scale, conversion value,
upper and lower limits, output value if there is an error and digital output filter.
The START and END push-buttons under the SW2 DIP-switch group allow to set the beginning and end
scale at will, within the scale pre-set through the dip-switches. To obtain this facility it is necessary to use
a suitable signal generator, able to furnish the desidered values of beginning and end scale.
The procedure is following:
1. Set through dip-switches the type of input, START and END measurement which include the required
beginning and end values.
2. Power up the module.
3. Supply a calibrator or simulator of the signal you wish to measure and re-transmit.
4. Set the required START value on the calibrator (or other instrument).
5. Press the START push-button for at least 3 sec. The green LED on the front panel flashes to indicate
the value has been stored.
6. Repeat points 4 and 5 for the required END value.
7. Power off the module and set to OFF position the dip-switches of group SW2, correspondent to the
settings of START and END values.
The module is now configured for the required start and end scale.
In order to re-program it (e.g. for a different type of input) repeat the whole procedure.
6.2
START AND END SETTING AT WILL
SW2 group DIP-switches 7 and 8 enable you to set the output with or without zero elevation and/or
as a normal or reversed output. The SW3 DIP-switch group enables you to select the output type.
Note:The DIP-switches must be set while the module is powered down, avoiding electrostatic
discharge, otherwise the module may be damaged.
6.3 OUTPUT SELECTION
