200 CORE STRAIGHT JOIN CLOSED – 200 CORE CURVED RAMP OPEN
Turn the ramp over so the surfaces are facing up. Press firmly / manipulate the surfaces at the join so the ramp is STRAIGHT or
CURVED depending which model you have purchased. The Edge of the Surface at the join should be flush / touching!
The Join between the side panels should be closed on the straight ramp and slight open on the curved ramp. Then secure /
tighten all 8 of these bolts. All 8 bolts should be set at 12 Nm for maximum security and checked regularly.
STAGE 9:
Take one FRONT Leg / BLOCKS and place this onto the side of the ramp. Secure the leg to the Side Panel using 1 x M10 x 40
Button Head bolt and one LARGE Washer to 12 Nm. There is ONLY ONE hole in the side panel for this BLOCK / FOOT.
ESSENTIAL:
ALWAYS remember to catch the thread of bolts with your fingers first to PREVENT / AVOID CROSS THREADING!
Never use an impact gun / drill to catch the thread.
Turn the Ramp over and attach the second LEG / BLOCK and tighten to 12 Nm.
STAGE 10:
Take one of the Curved Rear Legs and place this onto the side of the ramp. Secure the leg to the Side Panel using 2 x M10 x 40
Button Head bolts and a 2 Large Washers. One bolt goes into the slot and the other into a smaller slot. This smaller slot allows a
small amount of terrain adjustment. The Large slot allows you to swing the legs into storage mode (described later).