The
BACK PLATE
is also secured in the middle at the edge of the surface. YOU MUST DRILL AND SECURE AT A
SLIGHT ANGLE!
To
prevent the plywood bulging or the screw appearing on the front or back of the BACK PLATE! There are 3 additional fixing points
on the surface. One on either edge and one in the centre.
STAGE 8:
Installing the joining block. Take both sections of ramp and place them side by side so the VERTICAL JOIN TOUCHES (STRAIGHT
RAMP ONLY) Curved Ramps do not touch. Take the joining block with the corresponding holes as shown below and place this
behind the side panels. There are four PERMANENT fixing bolts points that should only be untightened or removed to relocate /
adjust the block or to place in Super Compact Mode.
Take 4 x M10 x 35 mm Countersink Bolts and place these through the side panel into the T Nuts on the joining plate. Catch the
thread by hand first then wind until
FINGER TIGHT ONLY!
Turn the ramp over and fit the second joining plate to the ramp sides with 4 x M10 x 35 Countersink Bolts and wind until
FINGER
TIGHT ONLY! PLEASE NOTE THAT THE SIDES OF A CORE 200 CURVED RAMP ARE OPEN ANGLED