MRD 6000
– User Manual
Page 16 (112)
2.1 Rack Installation
To install the MRD 6000 into a rack use the following steps:
1. Determine the desired position in the rack for the MRD
6000 making sure that the air intake on the front of the
unit and the exhausts on the sides of the unit will not be
obstructed.
2. Insert the rack mount clips into place over the
mounting holes in the rack.
3. Slide the MRD 6000 into position in the rack.
4. Secure the MRD 6000 to the rack by installing the four
supplied screws through the front mounting holes and
tightening.
5. If needed, secure a grounding wire use the grounding
location on the rear panel of the MRD 6000. See
Section 1.3 for grounding location.
2.2 Power Connection
Using the proper power connections is vital to the safe operation of the MRD 6000. Only
use the supplied 3-prong power connector or one with equal specifications. NEVER
tamper with or remove the 3
rd
– prong grounding pin. This could cause damage to the
MRD 6000, personnel and/or property.
2.3 AC Power Connection
The MRD 6000 is intended for use on either 120V or 240V systems. The power supply
will automatically detect the system it is connected to. To hook up the power use the
following steps:
1. Locate the AC power cord that was included with the MRD 6000.
2. Plug the female end of the power cord (end with no prongs) into the back of the
unit.
3. Locate a protected outlet (usually inside of the rack) to plug the male end of the
power cable into.
