Senci SC13000ATS, User Manual

Page: 80 / 87

Troubleshooting
Problem Solution
Engine is running, but no AC
output is available.
1. Reset circuit breaker. 2. Check and repair. 3.
Connect another device that is in good
condition. 4. Contact SENCI Authorized servic
Center.
Safety Instructions & Operator’s Manual SUITABLE FOR SENCI POWER PRODUCTS SINGLE / THREE PHASE GENERATOR DRIVEN BY V-TWIN
ENGINE
IMPORTANT
The labels of SENCI Power Products contain very important emissions information and critical safety warnings. Read, Understand, and
Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any
questions about your SERVICE CENTER. SENCI product, contact your local authorized
WARNING CHEMICALS KNOWN TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER EPRODUCTIVE HARM. WASH HANDS AFTER
HANDLING.
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
80
Cause
1. Circuit breaker is open. 2. Poor
conncetion or defective cord set.
3. Connected device is bad. 4.
Fault in generator.
Engine runs good but bogs down
when loads are connected.
1. Disconnect shorted electrical load. 2. See
“Don’t Overload Generator”. 3. Contact SENCI
Authorized servic Center.
1. Short circuit in a connected
load. 2. generator is overloaded. 3.
Shorted generator circuit.
Engine will not start; or
starts and runs rough.
1. Fill petrol tank. 2. Turn petrol valve to the
“Open” position. 3. Fill crankcase to proper level.
1. Out of petrol. 2. Petrol valve is in
the “Closed” position. 3. Low oil
level.
Engine shuts down during operation.
1. Fill petrol tank. 2. Fill crankcase to proper level.
3. Place generator on level surface
1. Out of petrol. 2. Low oil level. 3.
Generator tipped at angle.
Engine lacks power.
See “Don’t Overload Generator”.
Load is too high