Senci SC13000ATS, User Manual

Page: 75 / 87

Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
75
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the
recommended oil and petrol. Remove Generator From Plywooden Case 1. Set plywooden case on a rigid flat
surface. 2. Carefully cut the packing straps of plywooden case. 3. Remove the whole plywooden case upward
with two people by holding its side face at the same time. 4. Remove all fixed Bolt which were attached to the
base pallet. 5. Remove generator from the pallet. BEFORE STARTING THE ENGINE Add Engine Oil
Place
generator on a level surface.
CAUTION Any attempt to crank or start the engine before it has been properly filled with the recommended oil
will result in equipment failure.
Please fill the engine with 1.3L qualified engine oil. Damage to equipment
resulting from failure to follow this instruction will void warranty.
NOTE: Check oil often during engine break-in.
NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Add Petrol NOTE: This engine is certified to operate on petrol only. It will not operate on paraffin, diesel or other
fuels.
WARNING
Petrol and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death.
WHEN ADDING PETROL
Turn generator OFF and let it cool at least 2 minutes before removing petrol cap.
Loosen cap slowly to relieve pressure in tank. Fill petrol tank outdoors. DO NOT overfill tank. Allow space for
petrol expansion. Keep petrol away from sparks, open flames, pilot lights, heat, and other ignition sources. DO
NOT light a cigarette or smoke.
1. Use clean, fresh, regular UNLEADED petrol with a minimum of 85 octane. DO NOT use petrol which contains
Methanol. DO NOT mix oil with petrol. 2. Clean area around petrol fill cap, remove cap. 3. Add regular unleaded
petrol to petrol tank. Be careful not to overfill. Allow about 4cm (1.5”) of tank space for petrol expansion (Figure I).
4. Install petrol cap and wipe up any spilled petrol.
USING THE GENERATOR
System Ground The generator has a system ground that connects the generator frame components to the
ground terminals on the AC output receptacles.
Special Requirements There may be National regulations, local codes, or ordinances that apply to the intended
use of the generator. Please consult a qualified electrician, electrical inspector, or the local agency having
jurisdiction.
In some areas, generators are required to be registered with local utility companies. If the
generator is used at a construction site, there may be additional regulations which must be observed.