Senci SC 8000D, User Manual, Page: 62 / 68

When the load is a resistive load such as incandescent, heater or common power tools, using electrical appliances can refer to rated
power. If the load is inductive and resistive mixed loads such as fluorescent lamps, mercury lamp, transformers, fans, small blowers or
inductors,using electrical appliances can only refer to 60% rated power.
！
NOTICE: WHEN GENERATOR REACH OPERATING SPEED THEN
CAN ADD LOAD . The following table list shows some household electrical appliances power for reference.
(a) Cold to start the motor need 5-7 times rated current.
(b) Because the temperature of the compressor head requirements 15 minutes after restarting
START ELECTROMOTOR
When start electromotor need large current, some electromotor especially phase motor with low power is hard to start and needs 5-7
times running current. Capacitor start motor needs 2-4 times running current. Permanent magnet motor need 1.5-2.5 times running
current.
When overloaded, the generator will not run basis on the power characteristic curve, the rotate speed of diesel engine doesn’t increase,
which couldn’t output enough power to drive electromotor to reach the working speed. The generator could make a response on a
large initial starting current. However, a sharp decline in engine speed, may cause generator stop. If allowed to run with a very low
speed, the motor windings will be ablated in a very short time, in this low speed operation it could lead to the stator and motor
windings burn out soon. Because of starting a large current just a moment, When the generator speed quickly rises to the operating
speed, the generator will not damage. If starting the electromotor is difficult in a short time, turn off other electrical loads and minimize
the load of the electromotor.
Italia Star Com Due S.R.L.
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
62