NOTES:
(1) Make sure that the cable is tied to the cable connector in order to
maintain the radio frequency transmission performance.
(2) The ground plane should be at least 3 meters above the ground.
(3) No obstruction can be existed within 3 meters from the antenna
(as shown in Fig 7~9).
(4) Straighten the remaining cable.
(5) Bending cable cord will increase loss of transmission power.
(6) Make a loop before pulling the cable into the house. The loop can
prevent rain from going into the house.
(7) The higher the antenna is installed the better the communication
will be.
(8) Keep the antenna and cable away from high-voltage sources to
avoid electric shocks. Don't install the antenna in the rain to avoid
thunder striking.
Over 3 M (correct)
Over 3 M (correct)
Over 3 M (correct)
Over 3 M
(correct)
Less than 3 M
(incorrect)
Less than 3 M (incorrect)
Figure 7
Figure 8
Figure 9
16
21
F. Redial:
G. Call waiting/Receiving a second call:
H. Intercom:
I. Transferring calls:
J. Walkie-Talkie between handsets:
K. Voice Volume:
Press RD/P key from TALK Mode
From TALK MODE, the TALK key operates as a FLASH function that
allows you to place the first call on hold. Placing TALK Key again will
return you to the first call, placing the second call on hold.
1. Paging the base from handset
a. Handset : From STANDBY mode, press INT key to establish the
Intercom
b. Base: When the other party's voice is heard, answer through the
microphone.
2. Paging the handset from base
a. Base: Press INTERCOM key to establish the intercom.
b. Handset: Press any key except END key to answer intercom
During a call in progress, you can press FUN key first and then
followed by:
* Either the ID number of the target handset to place the call on hold
and be transferred to target handset.
* or press 0 0 key to place the call on hold and be transferred to
base.
* or press key to transfer phone call to any one of the handsets.
1. Press FUN key, INT key then the ID number of the target handset to
establish this function.
2. During a call in progress, the call will be on hold.
3. You can continuously press smart switch to talk and release it to listen
To.
4. Base unit can join the conversation with two handsets by pressing
INTERCOM key. Pressing INTERCOM key again enables you to
disable this group conference.
5. You can press FUN INT key to communication with any one
of the other handsets.
6. During the conference proceeding, the multi-Talk indicator of base
Unit will be turned on.
Adjust the volume on the handset can be done during a call or when
in the TALK mode. When in the TALK mode, scrolling up or down the
smart switch can adjust the volume from 6 different levels.
*
*
