20
The Parani-MSP1000 has two ETHERNET ports. The users may configure the secondary ETHERNET
(eth1) to “Bridged with eth0” or “Bridged with pan0.”
z
Bridged with eth0
The eth1 will be bridged to eth0. If then, it works as a link fail-over of the eth0. When the eth0 is
unplugged, the Parani-MSP1000 sends packets through eth1 instead of eth0. While in this
operating, the IP address of eth1 is the IP address configured for the eth0. When the switching
from eth0 to eth1 or from eth1 to eth0 occurs, it doesn’t affect the TCP sessions.
z
Bridged with pan0
The eth1 will be bridged to network interface for Personal Area Network (pan0). The Parani-
MSP1000 treats the hosts connected via eth1 as the hosts Bluetooth profiles (PAN, LAP and
DUN). This means that the hosts connected to Parani-MSP1000 via eth1 are able to
communicate the hosts connected to Parani-MSP1000 via Bluetooth.
3.3. SYSLOG server Configuration
The Parani-MSP1000 supports the use of a remote message logging service, SYSLOG service for the
system and port data logging. To use the remote SYSLOG service, the user must specify the
SYSLOG server’s IP address and the facility to be used.
Figure 3-2
shows the SYSLOG server
configuration page which is located in the Web interface.
Figure 3-2 SYSLOG server configuration
To receive log messages from the Parani-MSP1000, the SYSLOG server must be configured as
“remote reception allowed”. If there is a firewall between the Parani-MSP1000 and the SYSLOG
server, there must be a rule that allows all outgoing and incoming UDP packets to travel across the
firewall.
The Parani-MSP1000 supports SYSLOG facilities from
local0
to
local7
. The user can employ
these facilities to save messages from the Parani-MSP1000 separately in the SYSLOG server.
If the SYSLOG service is enabled and the SYSLOG server configuration is properly set up, the user
may configure the storage location for the system log of the Parani-MSP1000 as SYSLOG server. For
more information about the configuration of system log storage location, please refer to 7.2 System
Summary of Contents for Parani-MSP1000
Page 3: ...3 Revision History Revision Date Name Description V0 0 1 2007 08 16 Hanjun Yeom Initial Draft...
Page 31: ...31 5 CF card Configuration 5 1 When using a flash memory card...
Page 45: ...45 Appendix 2 Parani MSP1000 Configuration files A 2 1 ip conf...
