41
Reference
AT+BTCSD, AT+BTKEY, AT+BTSD?, AT+BTSEC, ATD, ATZ, AT&F
B.3.25. AT+BTSEC,Authentication,Encryption
Response
OK
Purpose
Set authentication and data encryption
Parameters
Authentication
=0: Inactivate (Default)
Authentication
=1: Activate
Encryption
=0: Inactivate (Default)
Encryption
=1: Activate
Description
If the authentication is activated, the pin code must be set by AT+BTKEY command. Data
encryption cannot be used when authentication is not enabled, i.e.
Authentication
=0 and
Encryption
=1 will not work properly.
Reference
AT+BTCSD, AT+BTFP, AT+BTSD?, AT+BTSD?, ATZ, AT&F
B.3.26. AT+BTNAME=$
string
Response
OK
Purpose
Change device name
Parameters
$string
= New device name (Default=
”
E SDv1.0.0 -445566
”
)
Description
Parani-ESD can have a user friendly name for easy identification. The name allows up to
30 alpha-numeric characters.
Reference
AT+BTINFO?, AT+BTINQ?
Example
AT+BTNAME=
”
My-Parani-ESD
”
B.3.27. AT+BTLPM,n
Response
OK
Purpose
Set low power mode
Parameters
n=0: Inactivate (Default)
n=1: Activate
Description
During no data transmission, Parani-ESD can be in low power mode to save the power. It
takes a few seconds to wake the Parani-ESD out of low power mode.
B.3.28. AT&V
Response
S0:m0;S1:m1;
…
Sn:mn
OK
Purpose
Display all the S-register
Description
All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
Reference
ATS
B.3.29. ATSnn?
Response
value
OK
