19
Figure 3-9 Connection Wizard Window
In this example we will refer to the two Parani-ESDs as ESD1 and ESD2 respectively. To use this
menu, please do the following:
Step 1.
Connect ESD1 and then push the START button.
Step 2.
Disconnect ESD1, connect ESD2 and then push the Next button after setting up Slave
configuration.
Step 3.
Disconnect ESD2, once again connect the ESD1 and then push the Finish button. The pairing
configuration should be completed. Make sure that each Parani-ESD’s connect LED is on. At this
point, when both Parani-ESD’s are restarted the connection will be established automatically.
3.7 ParaniWizard
ParaniWizard is a Wizard program that will allow you to configure a pair of Parani-ESD’s for an
automatic connection. To make connection with Bluetooth devices other than Parani -ESD, use
ParaniWIN or AT commands on a terminal program.
In this example, we will refer to the two Parani-ESD’s as ESD1 and ESD2 respectively.
Install and run ParaniWizard.
