9
2: Getting Started
This chapter describes how to set up and configure the NEMO10 in the first place by using the test
bed included in the NEMO10-SK.
-
2.1 Board layout and connectors
explains the board layout for the NEMO10 and the test bed for
it and the connectors.
-
2.2 Connecting the Hardware
describes how to connect the power, the network, and the serial
device to the NEMO10.
-
2.3 Accessing Console Port
describes how to access the console port using a serial console at a
local site or telnet console at a remote site.
-
2.4 Command Usages
described how to use command set of the NEMO10 to configure and
view parameter values and status.
Following items are pre-required to get started.
- One DC power adapter (included in the NEMO10-SK package).
- One serial console cable for configuration (included in the NEMO10-SK package).
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
- Terminal emulation program running on the PC
- One Ethernet CAT5 cable
2.1 Board layout and connectors
2.1.1 The NEMO10 module
The NEMO10 is a DIL (Dual-In-Line) package module for on-board installation. It provides the external
interface pins for power, switch, LED, UART and the RJ45 connector for Ethernet. The pin-out of the
NEMO10 is described in the Table 2-1. Figure 2-1 shows the layout of the NEMO10.
