24
- Exit and reboot the device
Figure 2-18. Help screen
> help ip
set ip ipmode par1 par2 ...
- ipmode: static=Static IP / dhcp=DHCP / pppoe=PPPoE
- parameters:
if ipmode = static,
par1 = IP address,
par2 = subnet mask,
par3 = gateway
if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username,
par2 = PPPoE password
Figure 2-19. Help screen with ‘ip’group specified
2.4.4 ‘factorydefault’Command
With ‘factorydefault’command, users can load factory default parameter values in console. Command
usage of ‘factorydefault’is as follows:
factorydefault [option] + <CR>
where,
- if option is omitted, all parameters are set with factory default values.
- if option='-ip', all parameters except IP settings are set with factory default values.
Loaded values are not saved until ‘save’command invoked. After ‘factorydefault” command, ‘save’and
‘reboot’commands are required for changes to take effect.
> factorydefault (or factorydefault –ip)
OK
> save
OK
> reboot
Figure 2-20. Factory default reset screen
2.4.5 ‘save’Command
With ‘save’command, current parameter changes are saved to non-volatile memory. Command usage
of ‘save’command is as follows:
