13
Figure 2-1 The panel layout of the PS110
2.1.2. PS410/810 Panel Layout
The PS410/810 has three groups of LED indicator lamps to display the status, as shown in
Figure 2-2
and
Figure 2-3
(i.e. System, Ethernet and Serial ports). The first two lamps on the left side indicate
Power, Ready(PS810 only). The next two lamps are for Ethernet Link and Act. Next lamps indicate
Receive and Transmit of the serial port
. Table
2-2 describes the function of each LED indicator lamp.
Table 2-2 LED indicator lamps of the PS410/810
Lamps
Function
Power
Turned on if power is supplied
System
Ready
Turned on if system is ready to run (PS810 only)
LINK
Turned on if connected to Ethernet network
Ethernet
Act
Blinks whenever there is any activities such as incoming or outgoing
packets through the Pro Series Ethernet port
Rx
Blinks whenever there is any incoming data stream through the serial port of
the Pro Series
Serial port
Tx
Blinks whenever there is any outgoing data stream through the serial port of
the Pro Series
There is a factory reset switch near by Serial console port and user can use this switch to restore
factory default configuration.
For PS410 there are 4 DIP switches to set communication type of serial port. (Please refer to Section
4.2.6 and Appendix A for more detail information of serial communication type and its connection)