Chapter 10 Adjustment
Warning
: Before adjusting portion of the machine, cut the power first, and then make adjustment after
receiving instructions
10-1 Adjustment of Heater Temperature
Turn the heater temperature knob to the right to increase the temperature and turn left to reduce the
temperature. Depending on the type and size of the strap, the heater temperature may need to be If the
temperature is too short, the strap can not be welded; on the contrary, the strap will be welded over and
break. (Please refer to the diagram on the right)
10-2 Adjustment of cooling Timer
The timer is to adjust the press cooling time for the strap welding portion. The time is set long by turning this
knob clockwise and set short by turning counterclockwise. The range of the time is 0-0.4sec. The standard
setting is in the scale 4(0.15sec.). If the time is too short, the strap will break when the tension is bigger.
10-3 Jog switch
When something wrong with the machine you could press this button to run the machine step by step to
analysis the problem.
10-4 Auto/manual switch
You can choose the mode by pressing the button to change the operation automatically or by hand
10-5 Adjustment of Strap-collected Length in the Pool
This is to adjust the length of the strap collected in
the pool with the prefeed roller. The length gets long
when loosening the bolt and moving back the
balance block. The length gets short when loosening
the bolt and moving ahead the balance block. The
length of the strap is according to the size of the arch.
If the length is too long, not only the strap will not be
Balance block
Bolt
- 18 -
Switch
Balance bar
Supporting
point
+7(977) 478-08-97
Мазур
Руслан
+7(926) 571-19-50
Мазур
Руслан
Заказ
Оборудования
и
запчастей
