Model SSD1-HS
508.366.1488 | semshred.com Page 7
of 23
5 – Operation
Please read this section carefully
. Most problems occur during the first hours of operation. Most
problems can be eliminated by careful review of the operating, maintenance, and recommended service
instructions.
Product destruction rate depends on the material, size of media, and the desired particle size. All units
are equipped with timed shutdown to help prevent jamming of the disintegrator. When
Selector Switch
is in the
OFF DELAY
position, the disintegrator will run for an additional three to five minutes to clear
the chamber. This will help to prevent jams that would require some disassembly to gain access to the
cutting chamber.
5.1
Start-Up Procedure
NOTE:
The cutting chamber cabinet is equipped with safety switches that will immediately shutdown
the machine when either the door is opened or the feed mechanism is removed to prevent injury. Both
doors should remain closed while the machine is in operation. Do
NOT
use the door switch as a method
of shutting down the machine, as jams and possible injury can occur. Always use the selector switch to
initiate a timed shutdown and avoid jamming.
Pre-start-up:
ü
Familiarize yourself with all controls and button locations.
ü
Ensure that all guards and covers are in place.
ü
Ensure the area is clean.
ü
Check the vacuum capacity and install a new waste bag if necessary.
Start–up:
1.
Plug the machine into an appropriate receptacle.
2.
Make certain that the cabinet doors are closed. Safety switches will prevent startup if
either door is open.
3.
Pull top-feed door toward the front of the machine until it reaches a stop.
4.
Turn green selector switch to
START.
It will pop over to
ON
after turning to
START
.
5.
Listen for machine to engage.
5.2
Shutdown Procedure
To shut down the machine, wait 60 seconds after the last piece of media is fed despite its listed
feed rate, then turn the selector switch to the
OFF
position. This will initiate a timed shutdown.
The machine will continue to run for three minutes, while the cutting chamber, hopper, and
evacuation line are cleared of any partially destroyed material.
