SELMI Demoulding, User And Service Manual

Page: 23 / 54

DEMOULDING
19
4. Installation section
4.1. Positioning
Warning
Before positioning the machine check that the
machine, the associated accessories and the
parts supplied separately have not been
damaged during transportation.
It is the task of the Client to make sure that the
strength of the supporting surface, at the point of
installation, is adequate for the weight of the
machine.
The flooring at the point of installation must be
sufficiently level.
Isolate the machine from any potential vibrations
coming from other nearby machinery.
In the case where the machine or any of the
associated accessories are found damaged it is
important to alert the manufacturer of the found
anomaly so as to agree on the actions to be taken.
Attention
The machine must be placed on a level
surface;
for the other environmental
requirements necessary for optimal
functioning of the machine please see
sections 1.11 and
2.5..
4.2. Electrical connections
Attention
The connection of the machine to the
electrical system must be carried out by
personnel observing the legislation in force;
the characteristics of the electrical connection
must be compatible with the electrical
specifications of the machine which can be
found in the relevant section or on the
apposite plaque on the door of the electric
panel.
Attention
If the machine has been purchased to be
powered by a three phase line, make sure that
in the socket there is a connection to the
neutral wire. This is necessary for the
functioning of the machine.
Attention
Before starting any procedure make sure that
there are no objects inside the tank.
Attention
This operation should be carried out by a
technician or by a maintenance electrician.
4.3. Air compressed connection
In the picture below is showen the position of the
air connection plug.
Attention
Make sure the pressure is around 2 bar. The air
compressed must be disoiled and disidratated.
4.3. Installation of the machine
After carrying out the positioning operations and
connection to the electricity main and pneumatic
system, proceed with the following operations:

Cleaning the supplied accessories
Attention
Make sure that no objects used during
installation have been left in the tank; if so,
remove them.
4.4. Commissioning
Check that all of the above-described procedures
were done correctly.
Check that the emergency button is not pushed; if it
is, release it.
Power-on the machine by pressing the button on the
main switch. The display on the control panel will
light up to show that the machine is in STAND-BY.
Check that the safety and emergency protections
and control devices are working correctly.
Make sure the work zone is free of all objects not
needed for work and that there are no oil stains on
the floor.