16
A
B
3.3 Fitting the furling line
Feed the furling line through the line guide cover half with the screws. Feed the rope through the two
”channels” in the drum. Fit the first screw through the rope approximately 25 mm from the rope end. Then
tighten up the rope and push it into the jaw-slot before fitting the second screw. Do not overtighten the screws!
If the sail’s ultraviolet (UV) protection is fitted on the starboard side, the furling line shall exit on the port side
of the line drum and if the UV protection is fitted on the port side the line shall exit on the starboard side.
3.4 Fitting the brims and
the line cover
1. Fit the four brims.
2. Fit the line-cover halves. Tighten the upper screws (B).
Do not over-tighten.
Tighten the lower screws (A) moderately. Fine adjustment of
the cover will be made after feeding the line on to the drum.
3. Feed approximately 30 turns of furling line on to the drum by turning the toggle clockwise if the line shall
exit on portside of the drum, anti-clockwise if it shall exit to starboard. Fine tuning of the drum is described in
chapter 5.3.
