27
1. Start by loosening the screw on the underside of the drum unit a few turns. Then loosen the two smaller screws
on each side of the line guide fitting until the line guide fitting and cover seperates. Remove the line guide
fitting. It may be necessary to loosen the screw on the underside a few extra turns for the line guide fitting
to come off.
2. Pull out the lock block.
3.
Remove the cover.
6.4 Dismantling
Never take the halyard swivel or the drum unit apart. You will find it difficult to re-assemble them correctly.
(The ball-bearings are loose and difficult to refit!) Contact your Furlex dealer if service is required.
6.4.2 Line guide and cover
6.4.1 Sail feeder
1.
2.
Bend open the connector slightly and pull out the sail
feeder - lower end first.
Bend the connector open and remove it.
Fig. 6.4.1.a
Fig. 6.4.1.b
Fig. 6.4.2.a
Fig. 6.4.2.b
Fig. 6.4.2.c
