Selbit ISP-12F, Manual Handbook

Page: 26 / 33

www.selbit.pl
- 26 -
CHAPTER 7
Manual mode cutting
Cutting in this mode enable arranging own cutting program using “board by board”
method. Programming goes from the position 1 (first cutting level from the bottom) trough
programmed cutting levels and ends on the actual head saw height.
Reaching this final level is shown as a position blinking on the display which overlap
settled height. One program is used for cutting one log and is not stored in the controller’s
memory. To programmed the controller for own cutting mode, please follow the instruction
below. Set up the head saw on the top of the log (level of the last cutting). Then press shortly
“Manual Program” and “Program” led is on and controller displays “Str Pro” and then
position number 1 and waits for data input (position 1 from the bottom). After providing
above value please use up arrow button and provide position number 2. Continue to provide
all required position of the cutting. When provided values exceeds head saw level, provided
position number when it is happening will be blinking. At any moment during manual
programming there is a possibility of leveling the head saw using “start/Nex Cut” button.
After providing all levels for own cutting program and we don’t want to use settled backward
head saw height (mode where cut board is taking away from the log after each cutting
operation) we can save program pressing shortly “Save Program”. When we want to use
settled backward head saw height (cutting without board taking away after each operation)
please settled the head saw on the required level just after the programming but before saving
and then press “Save Program” button. It cause automatically backward head saw height to be
stored (led “Height” is on) and the controller shows “Press Cut” on the display announcing
that head saw is not on the first cut level. Next please press “Start/Next Cut” and controller
sets up the saw on the first cut level and now the cutting process is starts in manual mode.