Selbit ISP-12F, Manual Handbook

Page: 15 / 33

www.selbit.pl
- 15 -
(K-2) Setting of electrical parameters of the drive (continued)
Input by: ConF – FULL – drC -
Function
Value Description of the function
Ctt UUC Voltage vector control
(K-3) Configuration of control inputs
Input by: ConF – FULL – I-O -
Function
Value Description of the function
tCC 2C
2-wire control
tCt trn
Status change is required to trigger the input
Frd LII
Terminal DI1 triggers downward motion (forward)
rrS LI2
Terminal Di2 triggers upward movement (backward)
(K-4) Configuration of control inputs (continued)
Input by: ConF – FULL – Fun – PSS -
Function
Value Description of the function
PS2 LI3 Terminal DI3 triggers the set speed
PS4 LI4 Terminal DI4 triggers the set speed
SP2 10 Second set speed (not used)
SP3 10 Frequency of free movement to position (Hz)
SP4 = > from the value
set in the function tFr Frequency of fast motion (Hz)
(K-5) Configuration of control inputs (continued)
Input by: ConF – FULL – Fun – LPO-
Function
Value Description of the function
SAF LI6
Terminal DI6 – limit switch down
SAr LI5
Terminal DI5 – limit switch up
SAL LO
Triggering with a low logic state from limit switches
PAS rnP
Type of stop after a signal from limit switches (ramp)
dSF Std
Type of stop (standard)
nSTP nO
Limit switch operation memory (off)