-18-
• Adjust dimming as required.
• To remove illumination for short periods of time (less than 60 minutes) press STANDBY to extinguish the
illumination.
• To power down (when illumination is not required in the following 60 minutes) press the MAINS ON/OFF
button.
•
Confirm blue back light on the MAINS ON/OFF is OFF.
5.0 HAZARDS ASSOCIATED WITH IMPROPER USE
This device contains high
voltages.
Maintenance of this device
poses additional hazards.
Do not operate with the cover removed.
Failure to read and understand
these Instructions for Use is
hazardous.
Personnel tasked with maintenance of the device should fully familiarize
themselves with the contents of these Instructions for Use and
only attempt maintenance of the device once they have a complete
understanding of these Instructions.
Only qualified personnel shall inspect the unit for internal damage.
Employ only authorized and properly trained personnel to perform
maintenance functions.
5.1 FIELD MAINTENANCE INSTRUCTIONS
• READ FULLY BEFORE ATTEMPTING FIELD MAINTENANCE
•
Familiarize with all the instructions on all the device placards, including on the rear of the device. If
unable to read, move closer and increase illumination.
•
If, at any time after the installation, an event of dropping, fluid ingress, or other such event that could
reasonably create damage or a hazard STOP and arrange for qualified maintenance personnel to
inspect.
•
If, at any point, you suspect something is wrong then terminate operation of the Seiler’s LED Heliolux
by pressing the MAINS ON/OFF (blue switch with international 0/1 designation). The blue light
should be off.
•
Then remain the MAINS cable. Consult the factory with information as to why the installation was
halted.
•
Do not use sharp instruments during field maintenance as doing so could damage internal
components and create a hazard.