P9
⑮
Installation of Antenna
（2）
Connection of Emergency Switch (Auxiliary Limit Switch)
As for the emergency switch, please either get it ready yourself or use the company-made one
LMS-208A (sold separately).
※
For safety precautions, install the emergency switch (auxiliary limit switch).
（3）
Connection of Tape Switch
Please make a tape switch ready
yourself.
When you use a tape switch, use the
company-made(sold separately) for
connection.
Remove the blue and transparent
protection film from the connective
part for tape switch.
Turn over the splash-proof seal until
the connective part for tape switch
is visible.
※After connection finished, never fail
to put back the splash-proof seal,
otherwise a troule may be caused by
moisture, dust, or such.
Upon delivery a short-circuit connector is connected.
In installing the emergency switch (auxiliary limit switch),
cut the cable of the short-circuit connector and connect it to
the switch.
（4）
Connection of Upper-& Lower- Limit Output
(for only the specification with upper-& lower-limit output)
Take off the blue and transparent protection film from
the connective part for upper-& lower- limit output,
and turn over the splash-proof seal until the connective
part for upper-& lower- limit output is visible.
Attach upper-& lower-limit ouutput harness packed
together to upper-& lower-limit output connector, and
link an equipment used to the connector.
(Refer to the following figure for the structure of
upper-& lower-limit output.)
※
For changeover between upper limit output and lower
limit output, see
“
Changeover between Upper-& Lower
Limit Outputs
”
in ⑪ on page 6.
※After connection finished, never fail to put back
the splash-proof seal,otherwise a troule may be caused
by moisture, dust, or such.
An antenna is a gateway to radio signals.
Operational distance may sometimes shorten according to installation conditions.
Install it according to the following procedure.
(1)Fix an antenna stand to the control panel with a screw.
(2)
Fix an antenna cable and an antenna to the antenna stand.
(3)Insert the plug of the antenna cable in an antenna plug mouth surely.
