Maintenance
Note
Light bulbs may become loose during shipping. If the flame effect is dim or does not operate properly at first, ensure that
the light bulbs are properly secured in the sockets (bulbs should be finger tighten, but do not over tighten). See “Replacing
Light Bulbs” Section of the manual for instructions.
When you first turn the heater on, it may emit a slight but harmless odor resulting from certain oils or greases being
heated as the appliance is used for the first time. This odor is perfectly safe and will stop shortly. It will not reoccur after
the first operation of this appliance.
This appliance comes equipped with an overheat protection safety device. Should the appliance begin to overheat for any
reason, it will automatically turn all heater functions of the appliance off. The appliance will have to be reset prior to continuing
use. To reset the overheat protection safety device, turn all controls off and unplug the appliance, wait 10 minutes, plug the
appliance back in and turn on.
Replacing Light Bulbs:
1. Take off the front glass panel.
2. Remove the four screws from the side panel, located on the front of the unit, and remove front panel.
3. Locate and examine the bulbs to determine which bulb(s) require replacement.
4. Unscrew the bulb(s) counter clockwise.
5. Insert new bulb(s).
Cleaning
1. To remove dust from glass window, please use clean dry cloth.
2. To remove fingerprints or other marks from glass window, please use clean damp cloth. Do not spray glass cleaner or
other liquids directly onto the window.
3. Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any air intake or exhaust
vents.
4. Do not use abrasive cleaners or spray liquids on any part of the appliance.
Warning:
Before attempting to perform any maintenance on this appliance, turn all controls to the
“OFF” position and unplug. Allow the appliance to be “OFF” For at least 10 minutes before
performing any maintenance in order to allow all components to cool properly.
Warning:
Do not exceed the recommended Bulb wattage.
Use only 120V, 40W candelabra base light bulb, the lamp holder is model E12.
Light Bulbs
Screws
Front panel
