sure that the product is connected to an outlet having the same configuration as the plug. No adapter should be used with
this product.
NOTE: A 15AMP,120 Volts circuit is required. Dedicated circuit is preferred but not essential in all cases, a dedicated
circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is
operating. Additional appliance on the same circuit may exceed the current rating of the circuit break.
WARNING:
1. Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord
is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
2. Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to
reduce the risk of fire, electric shock and injury to persons.
3. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons,
always use a licensed electrician.
Before Using This Appliance:
1. Before permanently placing your electric fireplace, plug it into a convenient outlet to verify that the circuit breakers
for the outlet are on.
2. Light bulbs may become loose during shipping, if the flame effect is dim or does not operate properly at first,
ensure that the light bulbs are properly secured in the sockets (bulbs should be finger tightened, don’t over tighten)
see “Replacing Light Bulb” section of this manual for instructions.
3. The information regarding this appliance can be found on the rating plate located on the back of the unit.
Plugging In the Heater:
1. Make sure the appliance main “I/O” is switch OFF(refer to operating instruction section).
2. Plug the unit into a no less 15Amp/120V outlet.
TECHNICAL SPECIFICATIONS
Model#
EA1119A
Rate Voltage
AC 120V, 60Hz
Rate Power(Total)
1400W
Power of Heating Apparatus
650W(Low)/1300W(High)
Flame effect Power
80W
Motor Power
20W
Specification of the Bulb (lamp holder) 2 Pcs E12
Using the Remote Control
This heater includes a remote control. To operate the appliance using the remote control, the Master Power Switch (A)
must be in the “ON” position. See below for directions to use the remote control:
ON/OFF BUTTON
DIMMER BUTTON
LOW HEATER BUTTON
HIGH HEATER BUTTON
