93
OPERATION
OPERATION
Remove the control switch from the passenger armrest storage
and connect the control switch to the power interface of the winch
located at the front of the vehicle.
1.
Open the waterproof cover of the power interface of the winch
switch.
2. Insert the control switch wire into the power interface.
Remote control operation
1
Release the winch cable
2
Reclaim the winch cable
NOTICE
When the remote control doesn’t work, it may be that the
battery in the remote control is exhausted. Replace the
battery with a new one.
When the winch is needed, the rope should be aligned with the
vehicle, preferably in a straight line. Too large an angle will change
the direction of tension and damage the cable. In case of serious
noise or vibration during the use of the winch, the operation of the
winch must be stopped immediately.
Summary of Contents for FUGLEMAN SGW1000F-U2 2022
