Sega THE HOUSE OF THE DEAD III DELUXE, Operator'S Manual

Page: 78 / 112

70
www.seuservice.com
71
www.seuservice.com
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
R B G
PIC-ADJ
SET
P
The Projector may be subject to color deviations affected by earth magnetism, the building steel
frames, etc. When the Projector is initially installed or the Projector's installation position is
changed, have the color matching performed automatically.
Keep pressing the P button (red) for approximately
3 seconds to have the ensuing movements
performed automatically.
When the green cross pattern movements are finished, similar
detection is performed sequentially in order of red and then blue
cross movements. After detecting by green, red and blue cross
movements, the game mode returns with the color deviation
status being corrected.
●
Although very rarely, the TRY AGAIN error display in red may appear. At this time, press
the P button (red) for approximately 3 seconds.
Even after the above operation is repeated, if the error condition still exists, then the display
shifts to PLEASE ADJ. In this case, the auto color matching function can not be used.
Contact the place of contact herein stated or where the product was purchased from.
●
If the automatic color matching indicates an error, color matching can manually be performed.
Refer to CONVERGENCE ADJUSTMENT (manual color matching).
The Projector will shift to the color
deviation correction mode from the
game mode, with the green cross
pattern appearing on the screen.
The cross pattern moves up/down
and right/left to start the movement
of searching the correct screen
position and inclination.
AUTOMATIC COLOR MATCHING
1