CONTROL
UNIT
65
10
10
CONTROLLER UNIT(S)
● Before starting work, be sure to turn the power off. Working without turning the
power off can cause an electric shock or short circuit.
● Be careful not to damage the cables. Damaged cables may cause electric
shock, short circuit or present a risk of fire.
● Exercise due caution in performing soldering procedures. If soldering iron is
handled carelessly, there could be fires or burns.
●
When fastening plastic parts, be careful not to tighten screws and nuts
excessively. Failure to observe this may damage the parts and cause injury
due to fragments resulting from damage.
● After the unit has been disassembled and reassembled again, check carefully
to be sure that there are no gaps or rattling at the junctions and that the trigger
can be operated smoothly. If there are gaps or rattling, or if operation is not
satisfactory, the players could get fingers or hands caught, resulting in injury.
● Be sure to inspect control unit surfaces for cracks and damage. Players could
be injured if they play when the unit is cracked or damaged.
● Assemble so that there is no gap between the L and R covers. If there is a gap
or rattling, the players could get fingers or hands caught, resulting in injury.
●
Do not cut the tie that holds the cables together inside the control unit. Doing so
can lead to connection failures with the connectors inside the unit. If the tie must
be cut to replace cables or perform other such work, make sure that they are
returned to the original position and tied together again.
● Once the product has been disassembled, use slack preventive agent (product
No. 090-0012). Coat screws with suitable amounts of this agent and then tighten
them. If this agent is not used, the product might start rattling or come apart.
● Use the slack preventive agent prescribed in these instructions. If any other
agent is used, there could be chemical changes that inhibit the use of screws
and part surfaces could be damaged.
● Be careful not to damage or lose small parts or screws.
● When a part has been replaced, be sure to always make adjustments and
check conditions in TEST MODE.
