Sega House Of The Dead 3 DELUXE, Service Manual

Page: 36 / 111

33
8. Remove the 2 tapping screws, and remove the microswitch from the slide mechanism.
9. Remove the solder and remove the microswitch.
SLIDE MACHANISM
1. Solder in the new microswitch, and assemble the Shotgun. When assembling, be careful not to
over-tighten the screws. Be especially careful when tightening the tapping screws.
2. Operate the trigger and grip, and make sure that the microswitch turns ON/OFF correctly.
REPLACING THE SENSOR UNIT
Follow instructions 1. through 4. of "Replacing the Microswitch" up to removing the left side cover.
1. Disconnect the connector and remove the Sensor Unit.
2. Remove the tapping screw, if required to gain better access.