39
CONTROL
UNIT
7
REPLACEMENT PROCEDURE
This procedure requires the following tools: Phillips screwdriver for the M4 screws, 1.5 mm hexagonal wrench, 11-
12 mm monkey wrench, nipper, cutter, wire stripper, soldering iron, industrial dryer and heat-shrinkable tube.
1
Remove the connectors.
2
Remove the 2 screws securing the VR Bracket and remove the entire Bracket and V.R. (See previous
instruction)
3
Loosen the 1 hexagon socket screws on the Gear Holder and remove the Gear Holder.
4
Remove the nut securing the VR Bracket, then separate the Volume from the VR Bracket and replace it.
5
Check to make sure the value on the Input Test screen is within the range 80H ± 8H when the steering unit
is in the straight position.
VOLUME POT
VOLUME POT BKT
VOLUME POT NUT
VOLUME POT WSHR
VOLUME POT GEAR
HEX SOCKET SCREW
CONTROL
UNIT
7
ADJUSTMENT PROCEDURE
1
Apply this procedure to both Horizontal and Vertical Volume Pots. Loosen the 2 screws that secure the VR
Bracket and move the VR Bracket to adjust the angle and condition of the gear alignment.
2
Locate the central position of the pot by turning the pot in both clockwise ans counterclockwise positions.
Once a central position of the pot has been determined, straighten the handle so that the gear is positioned
horizontally. Slide the pot into position engaging the gears.
3
Tighten the 2 screws and secure the VR Bracket and
the cover.
4
Check to make sure the value on the Input Test screen is within the range 80H ± 8H when the steering unit
is in the straight position.
H VOLUME BKT
7-2 ADJUSTING/REPLACING THE VOLUME POT
Be sure to perform volume's move value setting in the INPUT ASSIGNMENTS in the
Game Test Mode after replacing or adjusting the Volume.
LOOSEN FIXINGS
V VOLUME BKT
Summary of Contents for Giant Plants vs Zombies The Last Stand
