36
CONTROL
UNIT
7
•
When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
•
Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of
•
Exercise due caution in performing soldering work. If soldering iron is handled
carelessly, there could be
or burns.
•
When fastening plastic parts, be careful not to tighten screws or nuts excessively.
If these are tightened to excess, parts could be damaged, resulting in injuries
from fragments, etc.
•
After the unit has been disassembled and reassembled again, check carefully
that the unit has been reassembled correctly.
•
Be sure to inspect the outer covers on both gear and hand brake units.
•
Assemble so that there is no gap between the L and R covers. If there is a gap
or rattling, the players could get
or hands caught, resulting in injury.
•
Once the product has been disassembled, use slack preventive agent (product
No. : 090-0012-N). Coat screws with suitable amounts of this agent and then
tighten them. If this agent is not used, the product might start rattling or come
apart.
•
Use the slack preventive agent prescribed in these instructions. If any other
agent is used, there could be chemical changes that inhibit the use of screws
and part surfaces could be damaged.
•
Be careful not to damage or lose small parts or screws.
•
When a part has been replaced, be sure to always make adjustments and
check conditions in Test Mode.
7
CONTROLLER UNIT(S), SWITCHES AND BUTTONS
Summary of Contents for Giant Plants vs Zombies The Last Stand
