SEGA ENTERPRISES Confidential Mission, Owner'S Manual

Page: 69 / 113

FIG. 15 a
15. TROUBLESHOOTING
In case a problem occurs, first check wiring connector connections.
In order to prevent electric shock and short circuit, be sure to turn power off
before performing work.
Be careful so as not to damage wirings. Damaged wiring can cause electric
shock or short circuit.
After removing the cause of the functioning of the Circuit Protector, reinstate
the Circuit Protector. Depending on the cause of the functioning, using the
Circuit Protector as is without removing the cause can cause generation of
heat and fire hazard.
CIRCUIT PROTECTOR
Functions due to the activation of
bimetal. To restore the function,
wait for approximately one minute
or longer until the bimetal cools off.
(Press the Button.)
CIRCUIT PROTECTOR
PROBLEMS CAUSE COUNTERMEASURES
When the main
SW is turned ON,
the machine is not
activated.
The color on
MONITOR screen
is incorrect.
The on-screen
image of the
monitor sways
and or shrinks.
The power is not ON.
Incorrect power source/voltage.
AC UNIT CIRCUIT PROTECTOR
functioned due to instantaneous
overcurrent.
Image adjustment is inappropriate.
The power source and voltage are not
correct.
Firmly insert the plug into the outlet.
Make sure that the power supply/voltage are
correct.
First, remove the cause of overcurrent and
reinstate the circuit protector to its original
status (see 4 , Section 6, Refer to the
following).
Adjust appropriately (see Sec.11).
Make sure that the power supply and voltage
are correct.
TABLE 15 a
62