4
MCPE-1924 Installation
Packing List
Before you start to install the ODU, make sure the package contains the
following items
：
●
Wireless Outdoor CPE (Customer premise unit)
●
Mounting Kit * 1
●
Power Over Ethernet Kit * 1
●
Ground Connection * 1
●
2.5” /4” U bolts * 1 and Anchor * 4
●
RJ-45 Conector (1.5M) * 1
Hardware Installation
Once you check off everything from the package, you can start to install the
ODU. You can mount to a pipe, a pole or to the side of a building. The
steps are showed in the following
：
1. You must mount the ODU into the L bracket first.
Note: ALL the 4 screws had been tightened onto the ODU and
Bracket
2. You can use the U bolt to mount on the pipe, depending on
the radius of the pipe. (Wall mounting is referred to Wall Mounting
Figure) The two U bolts must be mounted tightly. Be aware of not
over-tighten the U bolt.
3. After checking the ODU is mounted well, you can connect the following
two cables: the Waterproof RJ-45 network cable to “P+ DATA OUT”
port of ODU and the RF cable to antenna port. Additional waterproof
tool, such as waterproof tape, is recommended to use to enhance the
waterproof function. It is suggested to have a lightening protector
between antenna and antenna port. Connecting the ground wire as
