4. SAFETY REQUIREMENTS
ATTENTION!
IT IS FORBIDDEN TO CONNECT THE EXTRACTOR
HOOD
TO THE NETWORK OF THE ELECTRIC COOKER.
PROTECT ELECTRIC CORD FROM MECHANICAL AND
THERMAL DAMAGE.
4.1
. While installing, the operation of conducting technical services, it is strictly forbidden to:
•
connect the extractor hood to the electricity network with a voltage and frequency that does not
correspond to those specified in paragraph 2;
•
use lighting lamps with a power output of more than
3 watts (LED);
•
carry out maintenance, replace lamps, remove filters, clean the extractor hood without removing the
plug from the mains socket;
•
operate the extractor hood with an open fire source, open gas burners or heating elements;
Heating
elements should be always covered with dishes;
•
prepare food with use of alcohol;
•
leave the fryer unattended;
•
operate the extractor hood with removed filters;
•
connect the extractor hood to the electric network of the cooker, cut the socket of the electric cord
while installing.
ATTENTION! IT IS FORBIDDEN TO USE GAS (ELECTRIC) COOKER IF THE EXTRACTOR
HOOD IS TURNED OFF.
4.2.
In order to avoid damage by electric current, the extractor hood must be plugged into a grounded
outlet.
4.3.
The extractor hood connected to the separate ventilation shaft. It is forbidden to connect other
appliances to the same ventilation shaft.
4.4
. Using the extractor hood together with other heating appliances (gas, oil, ovens, etc.), besides
electric,
it is necessary to provide the premises, it which the extractor hood is installed with the
additional flow of the fresh air (for example to open the window).
4.5.
For air extraction to the chimney use air duct
Ø150 / 120mm
. A smaller diameter will create
additional air resistance, which will increase noise and vibration, as well as motor overheating.
4.6.
Provide timely cleaning of non-disposable aluminum removal filters, otherwise, the efficiency of the
extraction will decrease and there will be a fire hazard due to the accumulation of grease and dust in the
filter.
4.7.
It is forbidden to turn on the extractor hood in case of ignition with the purpose of reduction of smoke
until complete localization of fire.
4.8.
In case of ignition under the extractor hood, cover the fire with a thick cloth, disconnect the extractor
from the electric network, do not use water to extinguish a fire in the places where the electrical appliances
are located.
4.9.
Protect the cord for connection to the electric network from the mechanic and thermal damages.
