5
3-1-2.
SC-09HDS rear side (Connection)
Please connect the camera, the monitor and related devices as below.
①
VIDEO INPUT
: Connect the nine (9) cameras
②
VIDEO OUT (Loop Through):
It distributes the nine (9) input video signals
to other devices by loop through.
③
MONITOR (Spot) Output:
Connect the SD (Standard Definition) Video
Monitor.
-
You can watch the picture of specific channel through the Monitor output,
independently from the video out in live through the HDMI, DVI and VGA
output.
-
Selection of Monitor output display
1.
Select MENU < SCREEN SETTING < SPOT
2.
Mouse: Click Right Button > MENU > Screen Setting > CVBS
3.
Front button: Press the MENU >
◀▶
buttons in display menu mode,
then press [Enter] >
▲▼
buttons. And then, press the [Enter] > +/-
button to change the set-up value.
4.
(Ch1~Ch9, HD9), HD9 displays the same picture as the picture
displayed through HDMI port.
5.
You can put out a single picture of 1~9CH or the picture entered
through HDMI port through the Monitor output port.
6.
You can watch two equal pictures through two BNC-F terminals of
Monitor port.
④
HDMI:
Connect the HD (High Definition) Monitor with HDMI input port.
⑤
VGA:
Connect the Monitor with the VGA input (Only it is possible in SXGA and
WSXGA mode.)
⑥
MOUSE:
Connect the mouse.
⑦
RJ-45:
Connect the Firmware Upgrade device.
⑧
,
⑨
Serial Port:
Connect the RS-232C/ RS-485 to link an external device.
-
Data configuration
Data bit
8
Stop bit
1
Parity
No
Baud rate
9600bps
- Packet structure (Control Communication Data format)
Byte
Value
Function
1
0xA0
STX (Launching Data)
2
0x00 ~ 0xFF
0x16 (Device Code)
3
0x00 ~ 0xFF
Address (Device ID)
4
Data byte
Control Data
5
Check Sum
Check Sum = Byte2 + Byte3 + Byte4
①② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩
