S-Series
5 Operation
12
5.5.3
DSP Page
1
Input source
2
Type of input: Selection menu (analog, AES3)
3
Hardware channel of the selected input: Selection menu (1...4)
4
Route In: Input source assigned to the path. Selection menu (a, b, c, d, a+b, c+d)
5
Name of the path: Editable via PC software
6
Group Values: Lights up green if group-wide parameters (EQ, Gain, Delay) are active.
Pressing the button resets all group-wide settings on the respective path
7
Loudspeaker: Selection menu for loading a loudspeaker (preset) from the internal library.
When loading multi-way loudspeakers, the amplifier channels on to the right are added to
this path.
8
M: Selection menu for the operating mode of the loaded speaker (e.g. Flat, HP, LP, Cardio,
etc.)
9
Way: Shows the speaker type or speaker way (e.g. Top, Sub, High, Mid, Low, etc.)
With single-channel loudspeakers, the path output is directly at the respective amplifier channels:
A=1, B=2, C=3, D=4. In the case of multi-way loudspeakers, the first path output is on the respec-
tive direct amplifier channel, the other loudspeaker ways are on the adjacent amplifier channels on
the right-hand side.
P1 Go to Home page
P2 Go to DSP page
P3 Go to Tune page
P4 Go to Utility page
P5 Cancel entries, go to Home page
